Creative Zig Zag Window Cornice

Here’s A Application Dedicated To Creative Zig Zag Window Cornice! Download

Create this custom window cornice in an afternoon. For a pulled together look consider using a favorite tablecloth to cover the cornice or match the fabric with your chairs.,

Completion time – 4 hours

Materials

STYROFOAM Brand Foam

Sheets, 36" x 12" x 1", two

Other Materials

Fabric, to cover cornice frame (our fabric

measured 54" x 36")

Quilt batting, 36" x 12" (optional)

Wood picks or toothpicks

Tools

Serrated knife or dental floss

Candle stub

Sharp pencil

Yardstick or ruler

Scissors

Straight pins

U-pins

Thick, white craft glue

Low-temp glue gun and glue sticks

(optional)

Iron and ironing board (optional)

Angle brackets with screws, 5", two

Instructions

Finished Size: 36" wide, 12" tall, 7" deep

(Note: The window shown is 34" across, and the cornice

measures 36" wide and 12" tall. If your window measurements

vary, adjust the sizes accordingly. For windows wider than

36", glue two sheets together along the 12" edges, joining

them with thick, white craft glue and wood picks or

toothpicks; u-pins inserted between the pieces will help

enhance the bond. Let glue dry completely before moving on to

the cornice construction.)

instructions:

1. Save one 36" x 12" foam sheet for front of cornice. Measure

two, 12" x 6" pieces on second foam sheet; score lines with

pencil. These will be side pieces. Wax serrated knife with

candle stub, and cut pieces from foam sheet. Or, try dental

floss: stand the sheet on its edge, and hold a 20" length of

dental floss along the scored line, positioning one hand at

the bottom of the board and the other at the top; draw the

dental floss down through the foam sheet along the scored line.

2. Refer to Fig. 1 to join sides to front. Place glue on three

wood picks, and insert into 12" edge of side piece. Using

thick, white craft glue or low temperature glue gun, join side

to front. Repeat with second side. Let dry completely.

3. If using quilt batting, cut 36" x 12" piece of batting. Glue to front of cornice.

4. Cut fabric strip measuring 54" x 28". Press fabric, if

needed. Center and pin fabric to cornice front; pins are

temporary and help hold fabric in place during assembly.

Carefully wrap fabric around cornice frame, neatly folding at

the corners and wrapping fabric onto the back. After cornice

is covered, glue fabric in place. If any of the cornice frame

is uncovered, cover with fabric scrap. If using pins to help

hold fabric in place on the reverse side, dip pins in glue

first, for better hold. Let glue dry.

5. Attach angle brackets to wall; slide cornice over them and pin in place.

for further information and detail tutorial, download this application now and you will have what you want.

please enjoy this tutorial and give us any feedback.