TCP Progr

Turn your Smartphone into Wireless Programmer/Debugger for Arduino/ESP82xx

Turn your Smartphone into Wireless Programmer/Debugger for Arduino/ESP82xx

Tested clones: UNO USB, UNO TTL, Mega 2560 USB, DUE USB, ESP8266 TTL, ESP8285 TTL.

On PC side you can use Arduino and Arduino-like IDEs(VisualMicro, Energia, Frizing).

To create virtual COM port useful are Tibbo VSP Manager(tibbo.com/soi/software.html) or HW VSP3(www.hw-group.com/products/hw_vsp/index_en.html).

Configure Virtual Port settings according the above pictures. IP address must be your smartphone address. Use this COM Port # in your Development Suite.

For communication with target device, FT232, CH340, CP2102 based USB-TTL adapters may be used. You should connect the adapter to smartphone before launching TCP Prog.

***NOTE***

Currently, it is not possible to program USB equipped ESP modules via USB, because of driver timing limitations, but it could be remarkable programmed via pins.